Other Error; Pdl Auto Switch Fail - Xerox Phaser 7100 Service Manual

Other Error

An unexpected error occurred during printing due to one of the following problems.
• Paper types cannot be determined because all the settings for Custom Paper Priority are set to
Disabled in CWIS, etc.
• This error is not related to the ART system commands/ forms.
• ESCP command error.
• Incorrect control code from the input stream, etc.
Applicable Fault Code
• 016-721: An unexpected error occurred at the PLW decomposer during printing
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. In CWIS, set the Custom Paper Priority to Enable.

PDL Auto Switch Fail

Print language auto judgment has failed. This does not occur in PCL5/ ESCP printers.
Applicable Fault Code
• 016-726: <Auto Judgment Error> Auto SW judgment has failed.
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. In CWIS, set a longer time for
2. Replace the parallel cable.
3. If a long parallel cable is used, use a short cable (genuine) and try printing again.
4. In CWIS, change the print language from
Print Mode.
>
Xerox Internal Use Only
by selecting Port Settings > Parallel.
Auto Output Time
Auto to ARTEX
.
.
or PS fixed by selecting
Phaser 7100 Service Manual 2-129
Error Troubleshooting
Emulation Settings