Rep 15.10 Turn Chute Assembly - Xerox Phaser 7100 Service Manual

Service Parts Disassembly

REP 15.10 Turn Chute Assembly

PL 15.1.15
1. Remove Tray 2/ 3/ 4.
2. Remove the 550 Left Feeder Cover
3. Disconnect the wiring harness connector P/J611 on the harness that is connected to the Turn
Chute Assembly.
4. Remove the harness that is connected to the Turn Chute Assembly from the Option Harness Cover
(PL 15.2.29).
5. Press the front of the Turn Chute Assembly down and toward the rear while rotating the Turn
Chute Assembly downwards.
6. Pull the Turn Chute Assembly temporarily to the front and remove it from the bottom.
7. Remove the harness that is connected to the Turn Chute Assembly from the corner hole.
4-270 Phaser 7100 Service Manual
(REP 15.8 550 Left Feeder Cover
P/J611
Harness
on page 4-268).
Option Harness Cover
Xerox Internal Use Only
s7100-289