Rep 4.5 Front Frame Sub Assembly - Xerox Phaser 7100 Service Manual

REP 4.5 Front Frame Sub Assembly

PL 4.2.9
WARNING: The Fuser may be hot. Turn the printer power Off and allow at least 30 minutes for
the Fuser to cool before removing the Fuser.
1. Remove Tray 1.
2. Remove the Fuser Unit
3. Remove the Transfer Roller (2nd BTR Unit)
page 4-108).
4. Remove the I/P PWB Cover Assembly
page 4-19).
5. Remove the Rear Cover
6. Remove the Left Side Cover
7. Remove the Right Side Cover
8. Remove the Left Feeder Cover
9. Remove the Right Feeder Cover
10. Remove the Control Panel Assembly
11. Remove the Bypass Tray Assembly
12. Remove the Bypass Tray Cover
page 4-71).
13. Remove the Front Cover Assembly
14. Remove the Front Frame Assembly
15. Remove the Right Latch Lever/ Left Latch Lever/ Latch Spring
Latch Spring on page 4-89).
16. Remove the Lever Shaft Assembly (PL 4.2.2).
17. Remove the Fuser Drive Assembly
18. Remove the Chute Assembly
Xerox Internal Use Only
(REP 10.1 Fuser Unit on page 4-183).
(REP 4.10 Transfer Roller (2nd BTR Unit)
(REP 1.5 Image Processor (I/P) PWB Cover Assembly
(REP 1.6 Rear Cover on page 4-20).
(REP 1.10 Left Side Cover
(REP 1.11 Right Side Cover
(REP 2.10 Left Feeder Cover
(REP 2.3 Right Feeder Cover
(REP 1.12 Control Panel Assembly
(REP 3.5 Bypass Tray Assembly
(REP 3.3 Bypass Tray Cover Assembly/ Exit 1 Cover/ Exit 2 Cover
(REP 1.15 Front Cover Assembly
(REP 4.1 Front Frame Assembly
(REP 4.7 Fuser Drive Assembly
(REP 4.8 Chute Assembly
Service Parts Disassembly
on page 4-25).
on page 4-27).
on page 4-49).
on page 4-40).
on page 4-29).
on page 4-73).
on page 4-35).
on page 4-74).
(REP 4.4 Right/ Left Latch Lever,
on page 4-99).
on page 4-103).
Phaser 7100 Service Manual
on
on
on
4-91