Job Ticket Out Of Memory; Job Ticket Wrong Parameter - Xerox Phaser 7100 Service Manual

Error Troubleshooting

Job Ticket Out of Memory

Insufficient memory was detected when the XPIF parser is interpreting the Job Ticket.
Applicable Fault Code
• 016-570: Insufficient XPIF Memory
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. At the Control Panel, increase the memory size for use by the Job Ticket, then reboot the printer and
perform the Job again.

Job Ticket Wrong Parameter

The decomposer detected an instruction content in the Job Ticket that cannot be applied within the
device specification.
Applicable Fault Code
• 016-571: Mismatched XPIF Parameters
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. Check the parameters that had been specified in Job Ticket for mismatches, correct the specification
as required, and then send the Job again.
2-118 Phaser 7100 Service Manual
.
.
Xerox Internal Use Only