Operation Mode; Running Mode; Ready Mode; Low Power Mode - Xerox Phaser 7100 Service Manual

Hide thumbs Also See for Phaser 7100:

Table of Contents

General and Operation Overview

Operation Mode

The following 4 modes are available in the Phaser 7100 printer: Running Mode, Ready Mode, Low

Power Mode, and Sleep Mode.

Running Mode contains operating states such as data receive/ image creation, or recording (print).

The printer is ready to print at Ready state. It is possible to enter this mode within the Warm Up Time

after power Off and On or from the Energy Saver Mode.

To reduce energy consumption, the printer will enter Low Power Mode when it has not received any

print data within a certain time after it has entered Ready Mode. The waiting time before switching to

this mode is set at 1 minute by default. It can be set in increments of 1 minute in the range between 1

and 60 minutes from the Control Panel. Furthermore, it can also changes when the Energy Saver

button is pressed. The printer can be set to prohibit the transition to Low Power Mode or Sleep Mode.

Furthermore, the printer will enter or exit the Low Power Mode when the Energy Saver button is

When the printer receives a Print Job or when the Energy Saver button on the Control Panel is pressed,

Low Power Mode will be canceled.

To reduce energy consumption, the printer will enter the Sleep Mode when it has not received any print

data within a certain time after it has entered the Ready Mode or the Low Power Mode. (When an

error, such as Out of Toner, has occurred, the printer will not transition to Sleep Mode unless the

transition condition has been fulfilled). The waiting time before switching to this mode is set as 1

minute by default. It can be set in increments of 1 minute in the range between 1 and 60 minutes from

the Control Panel. Furthermore, it can also transition when the Energy Saver button is pressed. The

printer can be set to prohibit the transition to Low Power Mode or Sleep Mode.

When the printer receives a Print Job or when the Energy Saver button on the Control Panel is pressed,

Sleep Mode will be canceled.

Phaser 7100 Service Manual

Xerox Internal Use Only