Lower Feeder Unit Troubleshooting; Misfeed At Tray 2 Paper Feed Section - Xerox Phaser 6115MFP Service Manual

General Troubleshooting

Lower Feeder Unit Troubleshooting

Misfeed at Tray 2 Paper Feed Section

4-12
For detection of misfeed at tray 2 paper feed section, the leading edge of the
paper does not block the Registration Sensor, even after the lapse of a
predetermined period of time after the Paper Pick-up Solenoid has been
energized.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor,
PL4.17.2
Paper Pick-up Solenoid,
PL5.2.16
Engine Control Board,
PL4.19.15
Warning
To avoid the potential of electric shock, ensure the power to the printer is
off and the power cord is disconnected from the wall outlet prior to
performing each step of the following troubleshooting procedure.
Troubleshooting Procedure Table
Step Action and Questions
1 Check the Engine Control Board
connector P/J22.
Is the connector seated properly?
2 Check the Registration Sensor at P/J12
(Pin 3). Is the sensor operational?
Check the Paper Pick-up Solenoid at
3
connector
P/J22 (Pin 4). Is the solenoid
operational?
Replace the Engine Control Board
4
(page 8-57).
Wiring and Plug/Jack References
Boards and Power Supplies Locator
(page 1-14).
Engine Control Board to Solenoid and Sensor
Wiring (page 10-13)
Engine Control Board to Duplex Unit and Feeder
Wiring (page 10-19)
Yes
Go to Step 2.
Go to Step 3.
Go to Step 4.
Complete
Phaser 6115MFP Multifunction Product Service Manual
No
Reseat the
connector. If the
problem
persists, go to
Step 2.
Replace the
sensor
(page 8-116).
Replace the
solenoid
(page 8-131).