Electrical; Rep 12.1 Hvps2 Pwb - Xerox Phaser 7100 Service Manual

Service Parts Disassembly

Electrical

REP 12.1 HVPS2 PWB

PL 12.1.2
CAUTION: PWB's can be damaged by an electrostatic discharge. Observe all ESD procedures to
avoid component damage.
CAUTION: Do not touch the IBT Belt surface.
1. Remove the IBT Unit
2. Remove the Top Cover Assembly
3. Remove 6 screws (silver, tapped, 8 mm) that secure the HVPS2 PWB to the HV Transfer Guide (PL
12.1.12).
4. Open the HVPS2 PWB and disconnect the wiring harness connector P/J552 and Ground connector.
5. Remove the HVPS2 PWB.
4-202 Phaser 7100 Service Manual
(REP 9.10 IBT Unit on page 4-177).
(REP 1.1 Top Cover Assembly
Rear View
P/J552
on page 4-9).
Ground Wire
Connector
s7100-270
Xerox Internal Use Only