HD Full by Annotation/ Watermark Image
When an Annotation/ Watermark image was to be stored in the HDD, Full status was detected and the
job was aborted.
Applicable Fault Code
•
016-708: Full During Annotation/ Analog Watermark Image Storage
Initial Actions
•
Power cycle the printer.
•
If the problem persists, perform the following procedure
Troubleshooting Procedure
Step
Actions and Questions
1.
Cancel Annotation/ Watermark and repeat the operation.
2.
Reduce the number of document pages. In Mixed Size mode, only a single size is available.
3.
For printing Stored Document, delete unnecessary documents from the HDD and repeat the
operation.
4.
Expand the capacity of the HDD partition of the relevant service.
Xerox Internal Use Only
.
Phaser 7100 Service Manual 2-125
Error Troubleshooting