Jam At Tray 2 (Feed Jam) - Xerox Phaser 6280 Service Manual

Jam at Tray 2 (Feed Jam)

Phaser 6280 Color Laser Printer Service Manual
Paper fed from Tray 2 did not reach the Registration Sensor on time.
Applicable Chain Link
Chain Link
Initial Actions
Ensure that Tray 1 (MPT) is attached to the printer.
Try picking paper from a different tray.
Check the paper path for obstructions or debris.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 1 (MPT) Retard Roller Assy.,
PL2.1.3
Roll Assy Feed (Feed Roll), PL3.1.10
Feeder Assy., PL3.2.1
Regi Sensor, PL3.2.30
Regi Sensor Harness, PL3.2.37
Feed Roll, PL3.2.53
MCU Board, PL9.1.20
Right Side Harness, PL10.1.15
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check for paper jam.
2. Remove the jammed paper.
3. Does the error still occur?
2 1. Perform the Registration Sensor
test (page 4-30):
Engine Diag
Sensor.
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
077-903: Jam at Tray 2
Wiring and Plug/Jack Map Reference
"Map 2 - Laser Unit, Feeder Assembly"
on page 10-10
"Map 4 - LVPS and MCU Boards" on
page 10-12
"Tray 1 (MPT) and Registration" on
page 10-23
"Feeder" on page 10-27
Service Mode >
> Sensor Test > Regi
Error Messages and Codes
Yes No
Go to step 2. Complete.
Go to step 8. Go to step 3.
3-45