Pcl Command Error - Xerox Phaser 7100 Service Manual

Error Troubleshooting
Out of PCL6 Memory
Insufficient memory was detected while using PCL.
Applicable Fault Code
• 016-719: Insufficient PCL6 Decomposer Memory
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. Increase the size of PCL memory. Increasing the overall system memory will in some measure
increase the memory to be allocated to the Decomposer.
2. The PCL memory cannot be explicitly increased through UI settings or other ways.
Therefore, if a job is aborted due to insufficient memory although the memory has been increased to
the maximum capacity, change the Print Driver settings to see if printing becomes possible.

PCL Command Error

A PCL command error occurred during PCL processing.
Applicable Fault Code
• 016-720: PCL Command Error Detected By PCL Decomposer
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. Cancel the job and try again.
2-128 Phaser 7100 Service Manual
.
.
Xerox Internal Use Only