Iq-17 Auger Mark - Xerox Phaser 7100 Service Manual

IQ-17 Auger Mark

Uneven density. Downward right slanted stripe patterns appearing in approximately 20 mm pitch.
Initial Action
• Check the paper transfer path is free of paper dust and debris.
Troubleshooting Reference
Applicable Parts
• Developer Housing Assembly (Y/ M/ C/ K), PL 8.1.5 - PL 8.1.8
• MCU PWB, PL 12.1.15
Troubleshooting Procedure
Step Actions and Questions
1. Check the installation surface of the printer (refer
to Clearance and Mounting Surface
Specifications
Is the printer installation surface flat, with no
bumps?
Are the legs of the printer installed properly?
2. Check for the color that is causing the problem.
Obtain a sample for the color problem or perform
color print.
Is the problem only with a particular color?
3. Replace the Developer Housing Assembly (Y/ M/
C/ K) (REP 8.1 Developer Housing Assembly (Y/
M/ C/ K) on page 4-137).
Does the error persist?
Xerox Internal Use Only
on page 1-38).
Example Print
Yes
Go to step 2.
Go to step 3.
Take action only for
the applicable color.
Replace the MCU PWB
(REP 12.4 MCU PWB
on page 4-206).
Phaser 7100 Service Manual
Image Quality
AugerMark
No
Correct the installation
surface.
Go to step 3.
Take action without
color restriction.
Troubleshooting
complete.
3-47