Marker Code Detection Fail - Xerox Phaser 7100 Service Manual

Marker Code Detection Fail

When expanding only the size that was specified at the expansion, the End Code (FF02) cannot be
found in the compressed data.
Applicable Fault Code
• 024-370: Marker Code Detection Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. If this occurs only with specific documents (most likely due to software malfunction):
a. Change the Print mode (Normal/ High Quality/ High Resolution).
b. This may occur when the RAM size is changed.
• Change the size of installed RAM.
• Change the RAM usage size. (Change the Port settings or the Receive Buffer size.)
2. If the problem persists, perform the following procedures.
• Go to Common System Fail
• Go to IOT System Fail
• Go to HDD System Fail
Xerox Internal Use Only
on page 2-406.
on page 2-407.
on page 2-408.
.
Phaser 7100 Service Manual 2-185
Error Troubleshooting