Duplex Jam Sensor - Xerox Phaser 7100 Service Manual

Duplex Jam Sensor

Troubleshooting Reference
Applicable Parts
• Duplex Harness Assembly, PL 4.2.18
• MCU PWB, PL 12.1.15
• Main Harness Assembly, PL 12.3.1
• Duplex PWB, PL 14.3.8
• Option Duplex Sensor Harness Assembly, PL 14.3.9
• Duplex Jam Sensor, PL 14.3.17
• Duplex Relay Harness Assembly, PL 14.3.19
Troubleshooting Procedure
Step Actions and Questions
1. Check the Duplex Jam Sensor operation.
Perform DC330 Component Control
page 2-26 [071-128] to check the operation of
the Duplex Jam Sensor.
Is the Duplex Jam Sensor operating properly?
2. Check the connection between the Duplex Jam
Sensor and Duplex PWB.
Are the connectors P/J125 and P/J430 connected
securely?
3. Check the conductivity between the Duplex Jam
Sensor and Duplex PWB.
Is the connection between P/J125 <=> P/J430
conducting properly?
4. Check the voltage supply (+3.3VDC) to the
Duplex Jam Sensor.
Measure the voltage between the Duplex PWB
GND <=> P/J430-1.
Is there a voltage (approx. +3.3VDC) output?
5. Check the voltage supply (+3.3VDC) to the
Duplex PWB.
Measure the voltage between the Duplex PWB
GND <=> P/J428-7.
Is there a voltage (approx. +3.3VDC) output?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
• Duplex
Replace the MCU PWB
(REP 12.4 MCU PWB
on
on page 4-206).
Go to step 3.
Go to step 5.
Replace the Duplex
Jam Sensor
Duplex Jam Sensor
page 4-259).
Replace the Duplex
PWB (REP 14.6 Duplex
PWB on page 4-257).
Error Troubleshooting
on page 7-62
Yes
Go to step 2.
Connect the
connectors P/J125 and
P/J430.
Replace the Option
Duplex Sensor Harness
Assembly.
Go to step 5.
(REP 14.7
on
Go to step 6.
Phaser 7100 Service Manual 2-445
No