Remote Directory Lock Error; Remote Lock Directory Remove Error - Xerox Phaser 7100 Service Manual

Error Troubleshooting

Remote Directory Lock Error

Creation of Lock directory has failed.
Applicable Fault Code
• 016-736: Repository Lock Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. When a lock directory (*.LCK) remained in the transfer destination, delete it manually and retry the
job.
2. Make correct settings for the permissions to the transfer destination directories.
3. Secure a disk capacity if the HDD for the transfer destination directory is full.

Remote Lock Directory Remove Error

Deletion of Lock directory has failed. The power was turned OFF because the CDI Cable got
disconnected during FTP transfer or the DFE Reset SW was pressed.
Applicable Fault Code
• 016-737: Lock Directory Deletion Error
Initial Actions
• Power cycle the printer.
• If the problem persists, perform the following procedure
Troubleshooting Procedure
Step Actions and Questions
1. When a lock directory (*.LCK) remained in the transfer destination, manually delete it and retry the
job.
2-134 Phaser 7100 Service Manual
.
.
Xerox Internal Use Only