Counter Mode Setting Area - Panasonic FP7 User Manual

13.4 Unit Memory Detailed Information
(Note 2) Always execute the interrupt clear instruction after setting, when selecting this setting.
(Note 3) Do not use this setting.
(Note 4) The default value when the power is on has been set to ""Not used"".
(Note 5) INT0 to INT7 correspond to CMP0 to CMP7 respectively. The interrupt occurs at the same timing as
the comparison output function.
(Note 6) This condition cannot be set as an interrupt condition on the unit Ver.1.0x.
Note that the interrupt setting itself is set to "not used" if the above condition is set as the interrupt
condition in FPWIN GR7 (Ver.2.12 or later).
● Target channels of the match interrupt when using the comparison output function are specified
in the area of the comparison output function.Refer to
Area".
● The above INT numbers are different from interrupt program numbers INTPG.

13.4.5 Counter Mode Setting Area

■
Counter mode setting
Unit
memory Name
No. (Hex)
Counter mode
setting
UM0010C
(CH0-CH1)
Counter mode
setting
UM 0010D
(CH2-CH3)
Allocation of unit memories
UM number UM0010D
Bit no. b15-b12
Setting
channel
Input
Setting item
mode
Setting
value
H0
Initial value
(Hex)
The values (Hex) of setting channel and setting item are written to the four bits of the unit
memory. When allocating them using the tool software, it is not necessary to write them.
13-30
Default
H 0F0F
H 0F0F
b11-b8 b7-b4
CH3
Input
Functions
mode
H F H0
"13.4.7 Comparison Output Setting
Setting range and description
Specify a counter mode. Each channel is
allocated 8 bits (input mode in 4 bits, function
in 4 bits).
UM0010C
b3-b0 b15-b12
CH2
Input
Functions
mode
H F H0
b11-b8 b7-b4
CH1
Input
Functions
mode
H F H0
WUME-FP7MXY-06
R W
A A
b3-b0
CH0
Functions
H F