Panasonic FP7 User Manual page 241

13.5 Unit Memory Detailed Information (H type)
13.5.1 Common Area
A: Available, -: Not available
Unit
memory Name
No. (Hex)
UM 00200 Axis setting
Positioning repeat
UM 00201
count (CH0)
Positioning repeat
UM 00202
count (CH1)
Positioning repeat
UM 00203
count (CH2)
Positioning repeat
UM 00204
count (CH3)
UM 00204
Reserved for system
-UM 00206
UM 00207 Error code
UM 00208 Reserved for system
Starting table number
UM 00209
(CH0)
Starting table number
UM 0020A
(CH1)
Starting table number
UM 0020B
(CH2)
WUME-FP7MXY-06
13.5 Unit Memory Detailed Information (H type)
Default Content
Stores used channels (axes) and usage methods.
Monitor using binary display.
bit no. Settings
0 Not use CH0 (0) / Use (1)
1 Not use CH1 (0) / Use (1)
2 Not use CH2 (0) / Use (1)
H0 3 Not use CH3 (0) / Use (1)
7-4 Disable the setting
8 Use CH0/CH1 as interpolation axis
Not use (0)/Use (1)
9 Use CH2/CH3 as interpolation axis
Not use (0)/Use (1)
15-10 Disable the setting
Stores the repeat count in decimal when using the
H0
repeat control in the position control.
Setting
H0
value
0 or 1
H0
2 to 254
H0
255 or
more
― ―
Stores a generated positioning error code in Hex
format (hexadecimal) when using the pulse output
function (table setting mode).
H0
* The higher 8 bits indicate the channel number and
the lower 8 bits indicate the error code.
― ―
H0
Specify the table number to be started when a
positioning start signal is input.
H0
Setting value: 1 to 20
When setting 0, the table number is 1.
H0
Operation
Not repeat an operation.
Repeat an operation for a specified
number of times.
Repeat an operation infinitely.
R W
A A
A A
A A
A A
A A
― ―
A A
― ―
A A
A A
A A
13-39