Panasonic FP7 User Manual page 101

The following figure shows the example of allocating ""Pulse output (Direction distinction)""
to the outputs (Y108-Y109) of the multi I/O unit. The control inputs for monitoring are
allocated to the inputs of the unit internal I/O (X118-X119), and the control output is
allocated to the outputs (Y118/Y11C/Y128/Y12C) automatically.
The set values will be effective when they are downloaded with programs or other
configuration information as a project.
Setting of counter elapsed value
The values set in the ""Pulse Output Advanced"" dialog box are applied as follows.
Item
PLS/PWM counter
elapsed value
(Note 1) The values in ""PLS/PWM counter elapsed value area"" of the channel to which the positioning
function has been set with the H type are the same as the values in ""Positioning elapsed value
(current value) area"".
● This function can also be set by writing to unit memories with user programs. For details on unit
memories, refer to
WUME-FP7MXY-06
Operation
The value set in the ""Counter elapsed value"" in the dialog
box is set in the PLS/PWM counter elapsed value area after
switching the mode to RUN mode.
""13.4.8 Pulse Output / PWM Output Setting
9.1 Pulse Output / PWM Output Function
Related unit memory
UM00170-UM00177
Area"".
9-5