Panasonic FP7 User Manual page 139

Parameter name
Starting table number
Simultaneous starting
table number
Home return method
Home return direction
Home return acceleration
time
Home return deceleration
time
Home return target
speed
Home return creep
speed
Deviation counter clear
time
Coordinate origin
JOG acceleration
(Note 1)
time
JOG deceleration
(Note 1)
time
JOG target speed
J point change target
speed
Emergency stop
deceleration time
Limit stop deceleration
time
(Note 1) When either of them is set to 0 ms, the target speed is output without acceleration/deceleration.
(Note 2) Set a value by converting to a deceleration time from 500 kHz to 0 kHz.
1.
Select Channel setting>Parameter settings from the menu bar.
The "Parameter Settings" dialog box is displayed.
WUME-FP7MXY-06
10.5 Positioning Table Settings (Configurator PMX)
Default (Unit) Settings
Specify the table number to be started when a positioning start
signal is input.
1
Setting value: 1 to 20
Specify the table number to be started when a positioning
simultaneous start signal is input.
Setting value: 0
0
Specified channels do not start simultaneously.
Setting value: 1 to 20
Specified channels start with the set table number.
DOG method 1, DOG method 2, DOG method 3, Home
Not use
position method, Data set method, Not use
Limit (-)
Limit (-) direction, Limit (+) direction
direction
100 (ms） Setting range: 1 to 10,000
100 (ms） Setting range: 1 to 10,000
1000 (pps） Setting range: 1 to 500,000
100 (pps） Setting range: 1 to 500,000
Setting range: 0 to 100
1 (ms）
For 0, no deviation counter clear signal is output.
When the home return method is Data set method, specify a
coordinate origin.
0 (Pulse)
Setting range: -1,073,741,824 to +1,073,741,823
0 (ms） Setting range: 0 to 10,000
0 (ms） Setting range: 0 to 10,000
1000 (pps） Setting range: 1 to 500,000
Set this setting for changing the speed during J-point control.
1000 (pps）
Setting range: 1 to 500,000
100 (ms）
Setting range: 1 to 10,000
100 (ms）
Setting range: 1 to 10,000
(Note 2)
(Note 2)
10-23