Panasonic FP7 User Manual page 23

LED Content
2 X0-XF
Input signal monitor
3 Y0-YF
Output signal monitor
Output polarity display
4 YN
4)
Output polarity display
5 YP
4)
Alarm/Error/Warning occurrence
6 ERR
display
(Note 1) The LEDs for the input and output both look as if they are continuously lit because the flashing speed
is fast when the frequencies of signals are high.
(Note 2) The LED for each input signal indicates the status after input time constant processing.
(Note 3) The output polarity display switches according to the output polarity setting using the tool software or a
program.
(Note 4) When the output polarity is not set by the software or program, both YN and YP will turn off. Also,
when the settings of sink, source, push-pull (negative logic) or push-pull (positive logic) are mixed, the
YN and YP turn on according to the polarity, and a warning occurs simultaneously.
2.1.3 Mode setting switches
No. Description
1 ON: Use the interrupt function, OFF: Not use the interrupt function
2
3 Not available. They should be always OFF.
4
(Note 1) At the factory setting, the mode setting switch number 1 is set to ""OFF"" (the setting not to use the
interrupt function).
WUME-FP7MXY-06
Col LED ON
or
Gre
(Note 1)(Note 2)
Displays the status of the input signal.
en
Gre
(Note 1) Displays the status of the output signal.
en
(Note 3)(Note
Gre Turns on when there is an output that is set to ""Sink
en output"" or ""Push-pull output (negative logic)"".
Turns on when there is an output that is set to
(Note 3)(Note
Gre
""Source output"" or ""Push-pull output (positive
en
logic)"".
Re At the time of alarm/
d error occurrence
2.1 Names and functions of parts
LED OFF
In normal
operation
LED Flashing
At the time of
warning
occurrence
2-3