Output Setting - Panasonic FP7 User Manual

Setting value
H 7
H8-HF
Precautions when making settings with programs
● When the setting value is that in the range of H8 to HF, the setting is invalid.
● When the setting value is that in the range of H0 to H7, the input time constant setting is
given priority over UM100-UM101.
● On the unit Ver.1.0x, the above input time constant values (the setting area of unit memories
UM00070 and UM00071) cannot be set with the tool softwrae (FPWIN GR7).
When the input time constants above are set in the tool software for the unit Ver.1.0x, they
are set as 2 µs. These values can be set by writing them into the unit memories using
programs.

13.4.3 Output Setting

■
Output terminal polarity setting
Unit memory
Name
No. (Hex)
Output polarity
UM00104
setting
Allocation of unit memories
UM number
Bit no.
Terminal number
I/O no.
Setting value
Initial value (Hex)
The values (Hex) of terminal number and I/O number (for four outputs) are written to the four
bits of the unit memory. When allocating them using the tool software, it is not necessary to
write them.
Setting value Output logic / Output polarity
H0 Sink output / Negative logic (The low side turns on when the operation result is TRUE (1).)
H 1 Source output / Positive logic (The high side turns on when the operation result is TRUE (1).)
H 2 Push-pull output/negative logic (Low side ON/high side OFF when the operation result is TRUE
(1))
H 3 Push-pull output/positive logic (High side ON/low side OFF when the operation result is TRUE
(1))
H4 to HE
Disabled
HF (Default)
Not used
WUME-FP7MXY-06
Valid/Invalid Input time constant effective pulse width
8 ms
Invalid -
Default
H FFFF
UM00104
b15-b12
B18-B15
YF-YC
H F
(Note 1)
(Note 2)
Output OFF
13.4 Unit Memory Detailed Information
Setting range and description
Set the value indicating output polarity. 4
points for 4 output terminals are allocated to 1
digit (4 bits).
b11-b8 b7-b4
B14-B11
YB-Y8
H F
b3-b0
A18-A15 A14-A11
Y7-Y4 Y3-Y0
H F
R W
A A
H F
13-27