Panasonic FP7 User Manual page 115

9.4 Execution Example of Pulse Output / PWM Output Function
■
Configuration
● Set the PWM output to the output (Y108).
● Select "PWM output" in the "Pulse Output Advanced" dialog box, and input the frequency
and duty.
● To change the frequency or duty ratio during the output, from data update timing, select
"When start signal rises or when data is updated" or "When start signal rises or when
comparison output is performed".
■
Time chart
If the rising of the start signal is detected when the enable input is on, pulses will be output.
When the enable input turns off, the pulse output will stop.
(1) If the rising edge of the start signal is detected when the enable signal is on, pulses will be output.
(2) Pulse output with a duty ratio of 50%.
(3) When the enable signal turns off, the pulse output will turn off.
(Note 1) The pulse output starts in the OFF period.
WUME-FP7MXY-06 9-19