10.11 Repeat Operation
10.11.1 Overview of Repeat Operation
● When the positioning table start contact is on, the unit repeats the operation set in the
positioning table.
■
Conditions of repeat control
Item
Operation pattern
Control method
Dwell time setting
■
Operation diagram (Setting operation on the table)
■
Operation diagram (Repeat operation)
■
Configurator PMX setting items
The repeat count is specified for executing the repeat control in Configurator PMX.
Parameter name
Positioning repeat count
WUME-FP7MXY-06
Repeat control is available
E-point control, P-point control + E-point
control, C-point control + E-point control
Increment mode
Set the table of E-point control to 1 ms or
more.
Unit
Default
times
0
10.11 Repeat Operation
Repeat control is unavailable
JOG operation, J-point control, Interpolation
control
Absolute mode
When setting 0 ms.
Settings
0 or 1
Not repeat an operation.
10-61