Sharp MX-4100N Service Manual page 75

Adjust the
section F so that
the clearance is
4.3mm - 5.0mm.
Increase the
clearance in
the section F
until there is a
resistance in
the section B.
However, the
max. is 5.0mm.
No
Is there a
resistance in the
section B?
Yes
MX-5001N ADJUSTMENTS 5 – 33
c) Adjust the section F.
Use a clearance gauge to check to confirm that the clearance
in the section F is 4.3mm - 5.0mm.
If not, turn the section E to adjust.
* Insert a clearance gauge in the range of 20mm from the
edge (a) of the right lower cover of the base.
a
20mm
* Turn section E clockwise to lift the RSPF unit. Turn it
counterclockwise to move down the RSPF unit.
F
E
F
a