Sharp MX-4100N Service Manual page 516
Digital full color multifunctional system
Hide thumbs
Also See for MX-4100N:
- Operation manual (903 pages) ,
- Quick start manual (120 pages) ,
- Software setup manual (44 pages)
Table of Contents
Advertisement
3)
Disconnect the connector and remove the screw, and remove
the controller cooling fan motor.
* When installing, put the fan label (A) facing outside, and the
harness (B) facing downward.
A
(6) Fusing fan motor
1)
Remove the paper exit unit.
2)
Remove the screw and disconnect the connector, and remove
the fusing fan motor.
* When installing, put the fan label (A) facing inside, and the
harness (B) facing downward.
A
B
(7) Process air inlet fan motor
1)
Remove the LSU.
2)
Remove the screw. Remove the duct. At the unit on its side
and disconnect the connector.
3)
Remove the screw and the snap band, and remove the pro-
cess air inlet fan motor.
B
(8) LSU cooling fan motor
1)
Remove the LSU.
2)
Remove the screw, and remove the LSU CNT PWB cover R.
3)
Disconnect the connector and remove the screw, and remove
the LSU cooling fan motor.
(9) Cartridge cooling fan motor
1)
Remove the screw (A) and disconnect the connector (B).
Remove the drive rear exhaust duct unit.
2)
Remove the screw (C) and disconnect the connector and the
harness. Remove the cartridge cooling fan motor.
A
MX-5001N FAN SECTION Q – 3
D
A
B
D
C
Advertisement
Table of Contents
