Sharp MX-4100N Service Manual page 246

Item/Display
G DENB-CS3 Tray 3 rear edge void
area adjustment
correction value
H DENB-CS4 Tray 4 rear edge void
area adjustment
correction value
I DENB-LCC LCC rear edge void aria
adjustment correction
value
J DENB-ADU ADU rear edge void aria
adjustment correction
value
K MULTI COUNT Number of print
L PAPER MFT Tray
selection
CS1
CS2
CS3
CS4
LCC
M DUPLEX YES Duplex
print
NO
selection
When the adjustment value is increased, the distance from the
paper lead edge to the image lead edge is increased. When the
adjustment value is decreased, the distance from the paper lead
edge to the image lead edge is decreased.
When the set value is changed by 1, the distance is changed by
about 0.1mm.
50-6
Purpose Adjustment
Function (Purpose) Used to adjust the copy image position and
the image loss. (RSPF/DSPF mode)
Section RSPF/DSPF
Operation/Procedure
1) Select an adjustment target item with [↑] [↓] key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
[DSPF]
Item/Display
A SIDE1
B SIDE2
Setting
Content
range
1 - 99
1 - 99
1 - 99
1 - 99
1 - 999
Manual 1 - 6 1
paper feed
Tray 1 2
Tray 2 3
Tray 3 4
Tray 4 5
LCC 6
Yes 0 - 1 0
No 1
Setting Default
Content
range value
Front surface 1 - 99
document scan
position
adjustment (CCD)
Back surface 1 - 99
document scan
position
adjustment (CCD)
MX-5001N SIMULATION 6 – 99
Default
value
50
50
50
50
1 Adjustment pattern print conditions setting
2 (CS1)
1 (NO)
Item/Display
C Image LEAD_EDGE
loss (SIDE1)
amount
setting
D FRONT_REAR
SIDE1
(SIDE1)
E TRAIL_EDGE
(SIDE1)
F Image LEAD_EDGE
loss (SIDE2)
amount
setting
G FRONT_REAR
SIDE2
(SIDE2)
H TRAIL_EDGE
(SIDE2)
I OFSET_SPF1
J OFSET_SPF2
K SCAN_SPEED_SPF1
[RSPF]
Item/Display
A SIDE1
50 B SIDE2
50 C Image LEAD_EDGE
loss (SIDE1)
amount
setting
SIDE1
NOTE
Setting Default
Content
range
Front surface lead 0 - 99
edge image loss
amount setting
Front surface side 0 - 99
image loss amount
setting
Front surface rear 0 - 99
edge image loss
amount setting
Back surface lead 0 - 99
edge image loss
amount setting
Back surface side 0 - 99
image loss amount
setting
Back surface rear 0 - 99
edge image loss
amount setting
DSPF front surface 1 - 99
document off-
center adjustment
DSPF back 1 - 99
surface document
off-center
adjustment
DSPF document 1 - 99
front surface
magnification ratio
(Sub scan)
Setting Default
Content
range
Front surface 1 - 99
document scan
position
adjustment (CCD)
Back surface 1 - 99
document scan
position
adjustment (CCD)
Front surface lead 0 - 99
edge image loss
amount setting
value
20
20
30
30
20
20
50
50
50
value
50
50
20