Sharp MX-4100N Service Manual page 217

Category Item/Display
For printer [PRINTER_S_VALUE]
[PRINTER_BASE_DITHER
_VALUE]
[PRINTER_AUTO_HT
_VALUE]
Previous [BEFORE S_VALUE]
correction
value
44-25
Purpose Setting
Function (Purpose) Used to set the calculating conditions of the
correction value for the half tone process
control.
Section Process
Operation/Procedure
1) Select a target adjustment color with [K] [C] [M] [Y] key.
2) Select a target adjustment density level with [↑] [↓] key on the
touch panel.
3) Enter the set value with 10-key.
4) Press [OK] key.
NOTE: Set the items to the default values unless a change is spe-
cially required.
Item/Display Content
A LOW FIELD Low density
LOWER LIMIT approximate
expression data
lower limit value
B LOW FIELD Low density
UPPER LIMIT approximate
expression data
upper limit value
C MID FIELD Medium density
LOWER LIMIT approximate
expression data
lower limit value
D MID FIELD Medium density
UPPER LIMIT approximate
expression data
upper limit value
E HIGHLIGHT Reference point of
POINT the highlight
correction amount
Content
Printer half tone process
control correction value
Printer half tone process
control reference dither
value
Printer auto density
adjustment correction value
Previous half tone process
control value
Default value
Setting
range
K CMY
0 - 255 98 2
0 - 255 60 40
0 - 255 90 15
0 - 255 6 144
1 - 8 7 7
MX-5001N SIMULATION 6 – 70
44-26
Purpose Adjustment/Setup
Function (Purpose) Used to execute the half tone process con-
trol compulsory.
Section Process
Operation/Procedure
Press [EXECUTE] key.
The half tone process control is performed and the operation data
are displayed.
COMPLETE Normal complete
ERROR COLOR SENSOR Color image density sensor sensitivity
ADJUSTMENT adjustment error
ERROR BLACK SENSOR Black image density sensor sensitivity
ADJUSTMENT adjustment error
[YMCK] High density process control error [YMCK]
error
OTHER Other errors
44-27
Purpose Data clear
Function (Purpose) Used to clear the correction data of the half
tone process control.
Section Process
Operation/Procedure
1) Press [EXECUTE] key.
2) Press [YES] key.
The correction data of the half tone process control are
cleared.