Sharp MX-4100N Service Manual page 181

26-10
Purpose Setting
Function (Purpose) Used to set the trial mode of the network
scanner.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
The set value in step 1) is saved.
TRIAL MODE 0
( 0 : YES 1 : NO )
1
26-18
Purpose Setting
Function (Purpose) Used to set Disable/Enable of the toner
save mode operation.
(For the Japan and the UK versions.)
Section
Operation/Procedure
1) Select an item to be set with [↑] [↓] keys.
2) Enter the set value with 10-key.
3) Press [OK] key.
The set value in step 2) is saved.
Item Display
A COPY 0 Copy toner save mode is inhibited.
1 Copy toner save mode is allowed
B PRINTER 0 Printer toner save mode is inhibited.
1 Printer toner save mode is allowed.
Trial mode setting
Trial mode cancel (Default)
Default
Content
value
MX-5001N SIMULATION 6 – 34
26-30
Purpose
Function (Purpose) Used to set the operation mode corre-
Section
Operation/Procedure
1) Enter the set value with 10-key.
0
1
2) Press [OK] key.
The set value in step 1) is saved.
* Even in Enable state, the control may not be executed due
to the power frequency, etc.
U.S.A 1 (CE not supported)
CANADA 1 (CE not supported)
INCH 1 (CE not supported)
JAPAN 1 (CE not supported)
AB_B 1 (CE not supported)
26-35
Purpose
Function (Purpose) Used to set the display mode of SIM 22-4
0
Section
0
Operation/Procedure
1) Enter the set value with 10-key.
0
1
2) Press [OK] key.
The set value in step 1) is saved.
Setting
sponding to the CE mark (Europe safety
standards). (For slow start to drive the fus-
ing heater lamp)
Control allowed
Control inhibited
EUROPE
U.K.
AUS.
AB_A
CHINA
Setting
trouble history when a same trouble
occurred repeatedly. There are two display
modes: display as one trouble and display
as several series of troubles.
Only once display.
Any time display.
0 (CE supported)
0 (CE supported)
0 (CE supported)
0 (CE supported)
0 (CE supported)