Sharp MX-4100N Service Manual page 144

2) Select [SETUP/PRINT] ADJ with the key button.
3) Select [ALL] with the key button.
(Note)
By pressing [LEAD] or [OFFSET] button, the following items
can be executed individually.
* [LEAD]: Print image lead edge image position adjustment
* [OFFSET]: Print image off-center adjustment
When [ALL] is selected, both of the above two items are
executed simultaneously.
4) Select a paper feed tray to be adjusted.
5) Press [EXECUTE] key.
The color patch image (adjustment pattern) is printed out.
6) Set the adjustment pattern on the document table. (Any direc-
tion)
NOTE: Fit the adjustment pattern correctly with the document
guide.
7) Press [EXECUTE] key.
The following item is automatically adjustment.
* Print image lead edge image position adjustment
* Print image off-center adjustment
8) Press [OK] key.
The adjustment result becomes valid.
Perform procedures 4) to 7) for each paper feed tray.
27-C
1) Enter the SIM50-28 mode.
2) Select [OC ADJ] with the key button.
3) Select the paper feed tray with paper in it with the key button.
(Any paper size will do.)
4) Press [EXECUTE] key.
The color patch image (adjustment pattern) is printed out.
5) Set the adjustment pattern on the document table.
(Any direction)
NOTE: Fit the adjustment pattern correctly with the document
MX-5001N ADJUSTMENTS 5 – 102
Copy lead edge image reference position
adjustment, image off-center, sub scanning
direction image magnification ratio
automatic adjustment
guide.