Sharp MX-4100N Service Manual page 249

50-12
Purpose Adjustment
Function (Purpose) Used to perform the scan image off-center
position adjustment. (The adjustment is
made separately for each scan mode.)
Section
Operation/Procedure
1) Select an adjustment target item with [↑] [↓] key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
When the adjustment value is increased, the image position is
shifted to the rear frame side. When the adjustment value is
decreased, it is shifted to the front frame side.
1step = 0.1mm
50-20
Purpose Adjustment
Function (Purpose) Image registration adjustment (Main scan-
ning direction) (Manual adjustment)
Section
Operation/Procedure
1) Select an adjustment target item with [↑] [↓] key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [EXECUTE] key. (The set value is saved.)
Item/Display
A CYAN (FRONT)
B CYAN (REAR)
C MAGENTA (FRONT)
D MAGENTA (REAR)
E YELLOW (FRONT)
F YELLOW (REAR)
G MULTICOUNT
H PAPER MFT
CS1
CS2
CS3
CS4
LCC
I DUPLEX YES
NO
Content
Image registration adjustment value (Main scanning direction) (Cyan)
(F side)
Image registration adjustment value (Main scanning direction) (Cyan)
(R side)
Image registration adjustment value (Main scanning direction) (Magenta)
(F side)
Image registration adjustment value (Main scanning direction) (Magenta)
(R side)
Image registration adjustment value (Main scanning direction) (Yellow)
(F side)
Image registration adjustment value (Main scanning direction) (Yellow)
(R side)
Number of print
Tray selection
Duplex print selection
MX-5001N SIMULATION 6 – 102
Item/Display Content
A OC Document table image off-
center adjustment
B SPF(SIDE1) SPF front surface image off-
center adjustment
C SPF(SIDE2) SPF back surface image off-
center adjustment
Setting range
1 - 199
1 - 199
1 - 199
1 - 199
1 - 199
1 - 199
1 - 999
1 Manual
paper feed
2 Tray 1
3 Tray 2
4 Tray 3
5 Tray 4
6 LCC
0 Select
1 Not select
Setting Default
range value
1 - 99 50
1 - 99 50
1 - 99 50
Default
NOTE
value
100 Adjustment Item
List
100
100
100
100
100
1
3 Adjustment
pattern print
conditions setting
1