Sharp MX-4100N Service Manual page 431

3. Disassembly and assembly
A. DSPF unit
1) Remove the upper cabinet rear cover lid. Remove the screw,
and remove the upper cabinet rear cover.
2) Remove the screw, and remove the earth line. Disconnect the
connector, and remove the snap band. Remove the screw, and
remove the locking band and the interface harness cover.
1
2
3) Loosen the screw, and lower the angle adjustment plate.
2
1
1
2
3
MX-5001N DSPF SECTION C – 5
4) Open the DSPF unit to put it straight up, and remove the
screw.
2
5) Slide the DSPF unit to the rear side, and fit the step screw with
the key hole of the hinge, and lift it up to remove.
(1) Front cabinet
1) Open the upper door, and remove the screw.
2
1
2
1