Sharp MX-4100N Service Manual page 492

: Oct. 24 2008
1
(4) Upper heater lamp
1) Remove the fusing unit.
2) Remove the fusing upper cover.
3) Remove the fusing upper cover FAS.
4) Remove the screw, and remove the upper lamp holder F. Dis-
connect the lamp connector on the rear side, and remove the
upper lamp harness from the upper lamp holder R.
NOTE: Put the upper heater lamp harness on the bent section
beside the upper lamp holder F and pass through the
clamp.
5) Disconnect the connector on the front side of the upper heater
lamp, and remove the upper heater lamp from the front side.
NOTE: When installing, check to confirm that the harness color on
the rear side is red or black.
NOTE: When installing, check to confirm that the section (A) of the
lower heater lamp is securely engaged with the lamp
holder.
(5) Lower heater lamp
1) Remove the fusing unit.
2) Remove the fusing upper cover.
3) Remove the fusing lower cover.
4) Remove the screw, and remove the clamp, the fusing upper
cover RAS, and the lower lamp holder F/R.
NOTE: The lamp harness is engaged with the fusing upper cover
RAS. Remove the lamp harness.
NOTE: Attach the clamp on the front side to the left side apart from
the lamp, and the clamp on the rear side to the right side.
MX-5001N FUSER SECTION M – 5
A
A
WHITE
A
1
RED
(41-sheet machine)
BLACK
(50-sheet machine)
A