Sharp MX-4100N Service Manual page 185

<List of Default values and set values for each destination>
Destination Toner preparation
message
U.S.A 0 (Displayed)
CANADA 0 (Displayed)
INCH 0 (Displayed)
JAPAN 0 (Displayed)
AB_B 0 (Displayed)
EUROPE 0 (Displayed)
U.K. 0 (Displayed)
AUS. 0 (Displayed)
AB_A 0 (Displayed)
CHINA 0 (Displayed)
(Contents of set items)
A: Enable/Disable setting of the toner preparation message display
when the toner remaining quantity reaches 25%.
B: Enable/Disable setting of the toner preparation message display
when the toner near end status is reached.
C: Enable/Disable setting of the machine operation when the toner
end status is reached.
For except Japan, performs operation of set value "3" regardless of
the setting value.
D: Setting of the allowable quantity of copy/print/FAX after display-
ing the message when item B is set to "0" (the message is dis-
played at toner near end). (Range: 0 - 200 sheets)
The number of output print allowed in item D is based on the
assumption that the sheets are of A4 size with print ratio of 5%.
(The number of outputs allowed differs depending on the paper
size and the print ratio.)
Set values of Item D and the number of output print allowed
1: Print Disable after toner near end
2: 25 sheets print Enable after toner near end
3: 50 sheets print Enable after toner near end
4: 100 sheets print Enable after toner near end
5: 200 sheets print Enable after toner near end
NOTE: When item B is set to "0" and item D to a desired number,
printing can be made after toner near end. However, insuf-
ficient density, thin spots, or improper color balance may be
resulted depending on the using conditions. When item D
is set to "1" printing is disabled after toner near end. this
case, toner end display is made in the toner near end sta-
tus, and copy/print/FAX outputs are disabled.
Set value
Toner near end message
0 (Displayed)
0 (Displayed)
0 (Displayed)
1 (Not Displayed)
0 (Displayed)
0 (Displayed)
0 (Displayed)
0 (Displayed)
0 (Displayed)
0 (Displayed)
MX-5001N SIMULATION 6 – 38
26-73
Purpose Setting
Function (Purpose) Enlargement continuous shoot, A3 wide
copy mode image loss (shade delete quan-
tity) adjustment
Section
Operation/Procedure
1) Select an item to be set with [↑] [↓] keys.
2) Enter the set value with 10-key.
3) Press [OK] key.
When the adjustment value is increased, the image loss
(shade delete quantity) is increased.
Item/Display Content
A DELETING Rear frame side
SHADOW ADJ image loss quantity
(M) (shade delete
quantity) adjustment
B DELETING Lead edge image
SHADOW ADJ loss quantity (shade
(S) delete quantity)
adjustment
26-74
Purpose Setting
Function (Purpose) Used to set the OSA trial mode.
Section
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key.
Item/Display
A OSA TRIAL 0
MODE
(0 : YES 1 : NO)
1
Setting
Default value
range
0 - 50 0
(Adjustment
amount:
0.1mm/step)
0 - 50 0
(Adjustment
amount:
0.1mm/step)
Setting Default
Content
range value
Used to set the 0 - 1
OSA trial mode.
OSA trial mode is
canceled.
1