Sharp MX-4100N Service Manual page 285

67-34
Purpose Adjustment/Setup
Function (Purpose) Used to set the density correction in the
printer high density section. (Support for
the high density section tone gap)
Section Printer
Operation/Procedure
1) Enter the set value with 10-key.
0 Enable
1 Disable
2) Press [OK] key. (The set value is saved.)
Item/Display
A CMY 0 CMY engine highest
(0: ENABLE density correction
1: DISABLE) mode : Enable
1 CMY engine highest
density correction
mode : Disable
B K 0 K engine highest
(0: ENABLE density correction
1: DISABLE) mode : Enable
1 K engine highest
density correction
mode : Disable
C CYAN MAX Scanner target value for
TARGET CYAN maximum density
correction
D MAGENTA MAX Scanner target value for
TARGET MAGENTA maximum
density correction
E YELLOW MAX Scanner target value for
TARGET YELLOW maximum
density correction
F BLACK MAX Scanner target value for
TARGET BLACK maximum density
correction
• When tone gap is generated in the high density section, set items
A and B to "0."
The density in the high density section is decreased, but tone
gap is reduced.
• To increase the density in the high density section further, set
items A and B to "1.
The tone gap may occur in high density part.
NOTE: Do not change the values of items C, D, E, and F. If these
values are changed, the density in the high density area is
changed.
Setting Default
Content
range value
0 - 1 0
0 - 1 1
0 - 999 500
0 - 999 500
0 - 999 500
0 - 999 500
MX-5001N SIMULATION 6 – 138
67-36
Purpose Adjustment/Setup
Function (Purpose) Used to adjust the density in the low den-
sity section.
Section Printer
Operation/Procedure
1) Enter the adjustment value using the 10-key.
2) Press [OK] key.
When the adjustment value is increased, the low density images
are strongly reduced. When the adjustment value is decreased, the
low density are images are weakly reproduced.
When tone gap is generated in the low density section (highlight
section), changing this adjustment value may improve the trouble.
67-52
Purpose Adjustment/Setup
Function (Purpose) Used to set the default of the gamma of the
printer screen. (for PCL/PS)
Section Printer
Operation/Procedure
1) Select a target default setting mode with the touch panel.
Press [ALL] key to select all the modes.
2) Press [EXECUTE] key and press [YES] key.
When the printer screen gamma was changed by SIM 67-33, it is
reset to the default.
Item/Display
Screen HEAVYPAPER
1200DPI_1BIT
600DPI_1BIT
B/W
Content
Heavy paper screen
SCREEN5(1200dpi 1bit Photo)
SCREEN6(1200dpi 1bit Graphics)
SCREEN1(600dpi 1bit Photo)
SCREEN2(600dpi 1bit Graphics)
SCREEN7(B/W 600dpi 1bit)
SCREEN8(B/W 600dpi 4bit)
SCREEN9(B/W 1200dpi 1bit)
SCREEN10(Toner Save B/W)