Sharp MX-4100N Service Manual page 221

: Oct. 24 2008
1
Item/Display
C PAPER MFT
CS1
CS2
CS3
CS4
LCC
[50-sheet machine]
1
Item/Display
A PRINT MODE 45deg
90deg
SET
VALUE
B PHASE(C)
C PHASE(M)
D PHASE(Y)
E PAPER MFT
CS1
CS2
CS3
CS4
LCC
44-37
Purpose Adjustment/Setup
Function (Purpose) Used to set the development bias correc-
tion level in the continuous printing opera-
tion.
Section
Operation/Procedure
1) Select a set target color with the touch panel.
2) Select a target item with [↑] [↓] buttons.
3) Enter the set value with 10-key.
4) Press [OK] key. (The set value is saved.)
NOTE:
When the print density is varied in the continuous printing opera-
tion, this simulation is used.
Tray selection Manual paper feed
Main unit 1 stage
Main unit 2 stage
Option paper feed desk 1 stage
Option paper feed desk 2 stage
LCC
Print mode 45 Deflection check pattern print for every 45 degrees (8-sheet
degrees print)
(1)0° (2)45° (3)90°(4)135° (5)180° (6)225° (7)270° (8)315°
* The number in () is printed on the output pattern.
90 Deflection check pattern print for every 90 degrees (4-sheet
degrees print)
(1)0° (2)90° (3)180° (4)270°
* The number in () is printed on the output pattern.
SET Deflection check pattern print at the set value (1-sheet print)
VALUE
Angle step 0° (1) → 45° (2) → 90° (3) → 135° (4) → 180° (5) →
C tandem phase setting
225° (6) → 270° (7) → 315° (8)
The phase of C is
changed by 45° each time
in the range of 0 - 315°.
Angle step 0° (1) → 45° (2) → 90° (3) → 135° (4) → 180° (5) →
M tandem phase setting
225° (6) → 270° (7) → 315° (8)
The phase of M is
changed by 45° each time
in the range of 0 - 315°.
Angle step 0° (1) → 45° (2) → 90° (3) → 135° (4) → 180° (5) →
Y tandem phase setting
225° (6) → 270° (7) → 315° (8)
The phase of Y is
changed by 45° each time
in the range of 0 - 315°.
Tray selection Manual paper feed
Main unit 1 stage
Main unit 2 stage
Option paper feed desk 1 stage
Option paper feed desk 2 stage
LCC
MX-5001N SIMULATION 6 – 74
Content
Content
Default
Setting range
value
1 1 - 6 3
(CS2)
2
3
4
5
6
Default
Setting range
value
1 1 - 3 3
(SET
VALUE)
2
3
1 - 8 2
1 - 8 4
1 - 8 5
1 1 - 6 3
(CS2)
2
3
4
5
6