Sharp MX-4100N Service Manual page 341

2) Remove the web roller (on the winding side).
Maintenance: Replace at every 150K.
* When installing, check to confirm that there are one concave
section on the front side and two concave sections on the
rear side, and be sure to engage them securely.
* When installing, engage the concave section (one position)
on the front side with the spring pin and two concave sec-
tions on the rear side with the web roller (on the feed side).
3) Remove two web tension shafts.
* When installing, insert the rear side first. Note that the front
side (gear side) of the shaft is narrower.
4) Remove the web roller (on the feed side) and the winding reg-
ulation gear.
Maintenance: Replace at every 150K.
* When installing, fit the concave section and the convex sec-
tion of the gear on the front side to engage securely.
[Route diagram]
[Note for installation]
Turn the gear (B) in the arrow direction, and set so that the lead
edge of the green line (A) of the web roller can be seen.
(6) CL pressure spring/lower CL roller/
lower CL roller bearing removal
1) Open the paper guide.
MX-5001N MAINTENANCE 8 – 26
B A