Sharp MX-4100N Service Manual page 515
Digital full color multifunctional system
Hide thumbs
Also See for MX-4100N:
- Operation manual (903 pages) ,
- Quick start manual (120 pages) ,
- Software setup manual (44 pages)
Table of Contents
Advertisement
4)
Disconnect the connector and remove the screw, and remove
the ozone fan motor from the filter box unit.
(3) Power cooling fan motor
1)
Remove the rear cabinet.
2)
Open the control box.
3)
Remove the filter box unit.
4)
Disconnect the connector and remove the screw, and remove
the power cooling fan.
* When installing, put the fan label (A) facing outside, and
arrange the engraved mark (B) in the blowing direction with
the arrow direction (C) of the metal plate.
C
(4) Power cooling fan motor2
1)
Remove the rear cabinet.
2)
Open the control box.
3)
Remove the filter box unit.
4)
Remove the screw, the reactor and disconnect the connector,
and remove the AC power PWB unit.
B
A
MX-5001N FAN SECTION Q – 2
5)
Disconnect the connector. Open the wire saddle, and remove
the harness. Remove the screw, and remove the DC power
unit.
6)
Remove the screw, and remove the power cooling fan motor.
* When installing, put the fan label (A) facing inside, and the
harness (B) facing upward.
(5) Controller cooling fan motor
1)
Remove the right cabinet rear cover.
2)
Remove the screw, and pull out the MFP cnt PWB.
B
A
Advertisement
Table of Contents
