Sharp MX-4100N Service Manual page 264

When the above operation is nor performed normally, "ERROR" is
displayed and. When the above operation is completed normally,
"COMPLETE" is displayed.
1 TRAYVOLMAX Tray size volume maximum value
2 TRAYVOLA4R Tray volume A4R size adjustment value
3 TRAYVOLA5R Tray volume A5R size adjustment value
4 TRAYVOLMIN Tray size volume minimum value
53-7
Purpose Adjustment/Setup
Function (Purpose) Used to adjust the RSPF/DSPF document
size width sensor.
Section
Operation/Procedure
1) Select an adjustment target item with [↑] [↓] key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
[RSPF]
Item/Display
A AD_MAX Max. width position
B AD_P1 A4R width position
C AD_P2 A5R width position
D AD_MIN Min. width position
[DSPF]
Item/Display
A AD_MAX Max. width position
B AD_P1 A4R width position
C AD_P2 A5R width position
D AD_MIN Min. width position
53-8
Purpose
Function (Purpose) Used to adjust the document lead edge ref-
Section
Operation/Procedure
Select an adjustment item with [AUTO] [MANUAL] key.
<AUTO: Document lead edge reference (RRCA) adjustment>(Auto
adjustment)
1)
2)
Item/Display
MEASUREMENT
DISTANCE
RRCA
<MANUAL: RSPF/DSPF mode document scan position adjust-
ment>
1)
2)
Item/Display
A
• When the adjustment value is increased, the scanner stop posi-
tion in the RSPF/DSPF mode is shifted to the right.
• When the adjustment value is changed by 1, the position is
Setting Default
shifted by 0.1mm.
range value
0 - 1023 72
0 - 1023 499
0 - 1023 805
0 - 1023 955
Setting Default
range value
0 - 1023 66
0 - 1023 438
0 - 1023 699
0 - 1023 893
MX-5001N SIMULATION 6 – 117
Adjustment
erence and the RSPF/DSPF mode docu-
ment scan position.
Set a sheet of black paper of A4 or 11"x 8.5" on the document
table.
Press [EXCUTE] key. (The adjustment is performed and the
adjustment value is saved.)
Content
Document lead edge
measurement distance
Document lead edge
reference position
Enter the set value with 10-key.
Press [OK] key. (The set value is saved.)
Content
ADJUST RSPF/DSPF mode document
VALUE scan position adjustment
(Scanner stop position
adjustment)
Setting Default
range value
0-255 -
(0.1mm unit)
0 - 99 50
Setting Default
range value
1 - 99 10