Sharp MX-4100N Service Manual page 435

(3) DSPF No.2 resist roller clutch
1) Remove the rear cabinet.
2) Disconnect the connector. Remove the clutch stopper (a), and
remove the DSPF No.2 resist roller clutch (b).
* When assembling, check to insure that the clutch rotation stop-
per is engaged with the plate.
1
E. Optical section
a DSPF CL inverter PWB
(1) DSPF CL inverter PWB
1) Remove the rear cabinet.
2) Disconnect the connector, and remove the control PWB unit.
3
1
2
3) Disconnect the connector, and remove the screw. Remove the
inverter PWB guide.
b
2
a
Parts
2
MX-5001N DSPF SECTION C – 9
4) Remove the screw, and remove the DSPF CL inverter PWB.
F. Drive unit
1
a DSPF paper feed motor
b DSPF paper exit motor
c DSPF lift-up motor
1) Remove the rear cabinet.
2) Remove the DSPF No.1 resist roller clutch.
3) Disconnect the connector, and open the edge saddle. Remove
the snap band.
a
b
c
Parts