Sharp MX-4100N Service Manual page 508

* Inserting position an inserting procedure when the DIMM
memory is removed
DIMM5
DIMM1: Option
DIMM2: 1GB
DIMM3: 512MB
DIMM4: Reserved (No option)
DIMM5: 512MB
3) Push Stopper (A) with your finger to release the lock holding
the memory PWB.
A
4) When the lock is released, the memory PWB tilts. Pull it out.
* Be sure to release the lock before pulling it out.
* Do not touch the IC on the memory PWB.
DIMM1
DIMM2
DIMM4
DIMM3
A
MX-5001N PWB SECTION P – 2
* Note for removing procedure of the memory PWB
Remove the PWB inside the tilt of the memory PWB first.
(Removing the IC outside the tilt will result in poor efficiency
of work.)
Outside Inside
* Note for installing procedure of the memory PWB
Install the PWB outside the tilt of the memory PWB first.
(Installing the IC inside the tilt will result in poor efficiency
of work.)
Outside Inside
a) Tilt the memory PWB and fit with the connector port. Put
the memory PWB up to the line (A) in the figure.
* When inserting, be sure to hold the both ends and be
sure not to touch the IC on the PWB.
b) Push the memory PWB which is kept tilted fully to the
bottom.
* Be careful not to tilt left and right.
* The gold plated section must be completely seated
inside slot.
Outside Inside
Outside Inside
About 15
A
[ Tilting left and right ]
[ The gold plated
section can be seen ]
[ Normal ]