Sharp MX-4100N Service Manual page 248

All adjustment items: 1 step = 0.1mm change
Items C - H are linked with items C - H of SIM50-06.
Item/Display
A BK-MAG
B MAIN-MFT
C MAIN-CS1
D MAIN-CS2
E MAIN-CS3
F MAIN-CS4
G MAIN-LCC
H MAIN-ADU
I SUB-MFT
J SUB-CS12
K SUB-CS34
L SUB-LCC
M SUB-ADU
N MULTI COUNT
O PAPER MFT
CS1
CS2
CS3
CS4
LCC
P DUPLEX YES
NO
Item A: When the set value is increased, the BK image magnifica-
tion ratio in the main scanning direction is increased. When the set
value is decreased, the image magnification ratio is decreased.
Item B - H: When the adjustment value is increased, it is shifted to
the front frame side. When the adjustment value is decreased, it is
shifted to the rear frame side.
All adjustment items: 1 step = 0.1mm change
Content
Main scan print magnification ratio BK
Print off center adjustment value
(Manual paper feed)
Print off center adjustment value (Tray 1)
Print off center adjustment value (Tray 2)
Print off center adjustment value (Tray 3)
Print off center adjustment value (Tray 4)
Print off center adjustment value
(Large capacity tray)
Print off center adjustment value (Duplex)
(NOTE) If the adjustment items A - G are
not properly adjusted, this adjustment
cannot be executed properly.
Resist motor ON Manual paper feed
timing adjustment
Standard cassette
DESK
LCC
ADU
Number of print
Tray selection Manual paper feed
Tray 1
Tray 2
Tray 3
Tray 4
LCC
Duplex print Yes
selection
No
MX-5001N SIMULATION 6 – 101
50-10
Purpose Adjustment
Function (Purpose) Used to adjust the black print image magni-
fication ratio and the off-center position.
(The adjustment is made separately for
each paper feed section.)
Section
Operation/Procedure
1) Select an adjustment target item with [↑] [↓] key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [EXECUTE] key. (The set value is saved.)
Default
Setting range
value
60 - 140 100 Adjustment Item List
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50 Adjustment Item List
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 99 50
1 - 999 1 Adjustment pattern print conditions setting
1 - 6 1 2 (CS1)
2
3
4
5
6
0 - 1 0 1 (NO)
1
NOTE