Assignable Fader Section; Usb Memory Connector - Roland M-5000 Reference Manual

Part Names and Functions

Assignable Fader Section

This section lets you assign any four channels of you choosing to the 4 assignable faders. This makes it possible to keep important channels accessible
at all times.
For details, refer to the "Assignable Fader Section" in the Reference Manual (PDF).
Name
Fader Bank display
[SEL] button
[SOLO] button
Level meter
[MUTE] button
Fader

USB MEMORY Connector

The M-5000 can use a USB flash drive to store and load a variety of data.
5 Project files
0"Saving a Project File to a USB Flash Drive" (p. 59)
0"Loading a Project File from a USB Flash Drive" (p. 60)
5 Recording and playback of WAV files using a USB flash drive
0"Recording/Playback to/from a USB Flash Drive" (p. 58)
NOTE
* Never turn off the power or disconnect a USB flash drive when the access light of the device is lit or blinking
* Carefully insert the USB flash drive all the way in—until it is firmly in place.
* Some USB flash drive types or USB flash drives from some manufacturers may not record or play back properly.
* All USB flash drives eventually wear out. We recommend that you consider the USB flash drive not as a permanent storage site, but as a place to
store data temporarily. We also recommend that you back up important data onto another media.
Memo
5 Before using a USB flash drive on this unit, please format the USB flash drives using the built-in format function.
0"Formatting a USB Flash Drive on the M-5000" (p. 61)
5 Some USB flash drives might not be able to be used on this unit. If an error message appears when formatting as described in "Formatting a USB
Flash Drive on the M-5000" (p. 61), it is not possible to use this USB flash drive on the M-5000.
5 The M-5000 supports only USB flash drives (USB flash Memory and USB memory). USB Hard Disk and Memory Card Readers are not supported.
5 USB flash drives do not work via USB hub.
30
Fader Bank display
[SEL] button
[SOLO] button
Level meter
[MUTE] button
Fader
Description
This displays information such as the input channel/output bus name and fader value. In the Function mode, it displays
information such as a list of functions and parameter values.
This selects the input channel/output bus and selects the display target. In the function mode, it selects the function
and manipulates parameters.
This turns solo on and off for the input channel/output bus.
This displays the signal level of the input channel/output bus.
This turns muting on and off for the input channel/output bus.
This operates the fader for the input channel/output bus.