Setting The Bass To Midi Function (System Parameters) - Roland V-Bass VB-99 Owner's Manual

Setting the BASS TO MIDI
Function (System Parameters)
These procedures are used for making settings for the device as a
whole. Changes are saved automatically, and the Write procedure is
not required.
After entering these parameters, press [EXIT] several times to return
to the Play screen.
Switching the BASS TO MIDI Function
On and Off
1.
Press [BASS TO MIDI].
The BASS TO MIDI screen appears.
2.
Set BASS TO MIDI to ON with [F1] (OFF/ON) or
the F1 knob.
Setting this to OFF prevents the output of all MIDI messages
related to the BASS TO MIDI function.
Chapter 5 Using MIDI
Selecting the Controller Used to
Control the Hold Function (HOLD CTL)
1.
Press [BASS TO MIDI].
The BASS TO MIDI screen appears.
2.
Press [F5] (SYSTEM).
3.
Use [F1] (SELECT) or the F1 knob to select the
controller you want to set.
HOLD CTL Controller
GK S1, S2 GK-3B DOWN/S1, UP/S2 switch
VB-99's CONTROL 1, 2 buttons or foot
CTL 1–4
switch connected to CTL 3,4 jack
FC-300's CTL 1, 2 pedals or foot switch con-
FC-300 CTL1–8
nected to CTL jacks 3–8
Controllers to which HOLD CTL is assigned are enabled
simultaneously with parameters set in the SYSTEM
CONTROL ASSIGN settings (p. 146). Set CONTROL
ASSIGN to OFF if you want to use only the Hold
function.
You can select the way the Hold function operates. For
more details, refer to "Selecting How the Hold
Functions (HOLD TYPE)" (p. 63).
59