Settings Concerning The Display And Controllers; Lcd Contrast - Roland Groovebox MC-307 Reference Manual

Settings Concerning the Display
and Controllers
* It is not possible to enter these set-up screens while a pattern
or song is being played back.
Adjusting the display contrast

(LCD CONTRAST)

This adjusts the contrast (brightness) of the Display.
Increasing this value will increase the contrast of the display.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up/down)] button to access the
screen for items 1–4.
3. Press the [F2 (LCD)] button.
4. Press [F1 (LCD)] button.
The SYSTEM: LCD" screen appears.
5. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: 1–16
Parameter Type: Backup parameters
Changing the velocity produced by
playing the keyboard pads
(PAD VELOCITY)
When you use the keyboard pads to play, all notes will be
sounded with the same velocity (strength). This setting
specifies the velocity that will be used. As this value is
increased, notes played from the keyboard pad will be
stronger.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up/down)] button to access the
screen for items 1–4.
3. Press the [F2 (LCD)] button.
4. Press [F2 (CTRL)] button.
The "SYSTEM: CONTROL" screen appears.
Chapter 7 Environment Configuration and
5. Use the [CURSOR (up/down)] buttons to move the
cursor to "PAD VELOCITY."
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Range: 1–127
Parameter Type: Backup parameters
Setting up the pedal (PEDAL ASSIGN)
This specifies the function of a pedal switch connected to the
PEDAL jack.
Procedure
1. Press the [SYSTEM] button, then the [F1 (SYS)] button.
The selection screen for system settings appears.
2. Press the [CURSOR (up)] button to access the screen for
items 1–4.
3. Press the [F2 (LCD)] button.
4. Press [F2 (CTRL)] button.
The "SYSTEM: CONTROL" screen appears.
5. Use the [CURSOR (up/down)] buttons to move the
cursor to "PEDAL ASSIGN."
6. Specify a value using the [VALUE] dial or the [INC/
DEC] buttons.
Available Settings:
- HOLD: The pedal will act as a Hold Pedal.
- PTN-I: (Pattern Increment)
With the Pattern Call function (P. 37) setting of ON, The
patterns of the currently selected pattern set will be
successively selected.
- TAP: The pedal will act like the TAP button.
- R-TPS: The pedal will act like the TRANSPOSE
button.
- PLAY: The pedal will act like the PLAY button /
STOP button.
- SOSTE: The pedal will act as a Sostenuto Pedal.
Parameter Type: Backup parameters
117