Having Values From An External Pedal, Gk Volume Control, Or Other Controller Carried Over When Patches Are Called Up (Assign Hold); Making System-Wide Settings For The Features Controlled By The Function Knobs (System Direct Edit) - Roland V-Bass VB-99 Owner's Manual

Having Values from an
External Pedal, GK VOLUME
Control, or Other Controller
Carried Over When Patches
are Called Up (ASSIGN HOLD)
This setting determines whether or not the current settings for each
controller (the expression pedals, the FC-300's expression pedals,
control pedals or other controllers) are applied to the patch when
patches are switched.
* Assign Hold is not performed when the SW MODE parameter in
Control Assign Source is set to LATCH. (LATCH toggles between
the minimum and maximum value each time the switch is pressed.)
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F4] (CTL).
4.
Press PAGE [ ] to display Page 2.
The Control screen appears.
5.
Select ON or OFF for the Assign Hold function
with [F1] (OFF/ON) or the F1 knob.
Settings Explanation
Current values of controllers are applied when
ON
patches are called up.
Stored values (at the time of Patch Write) of
OFF controllers are used when patches are called
up. (Current controller values ignored.)
Chapter 3 Global Device Settings (SYSTEM)
Making System-wide
Settings for the Features
Controlled by the Function
Knobs (SYSTEM DIRECT EDIT)
1.
Press [SYSTEM].
2.
Press PAGE [
3.
Press [F4] (CTL).
4.
Press PAGE [
The Control screen appears.
5.
Set the DIRECT EDIT parameter to SYSTEM
with [F2] (SELECT) or with the F2 knob.
If you want to be able to assign the functions for the
knobs on an individual patch basis, set DIRECT EDIT to
PATCH. With DIRECT EDIT set to PATCH, the unit
operates in accordance with the assignments set in each
patch, as described in "Changing the Sounds with the
Function Knobs as You Play (DIRECT EDIT)" (p. 76).
6.
Press Page [
you want to set.
7.
Use the [F1]–[F6] or F1–F6 knobs to select the
parameters you want to assign to the knob.
You can quickly locate and select the desired parameter
by first narrowing down the parameter type with F1
(F4), then using F2 (F5) and then F3 (F6) to reach the
right parameter.
] to display Page 1.
] [ ] to display Page 2.
] to go to the page for the knob
43