Table of Contents
Advertisement
Chapter 8. System Settings and MIDI Applications
Making system settings (System)
Here you can make settings that affect the operation of the entire D2, such as tuning and the synchronization method.
* It is not possible to enter these set-up screens while a pattern or song is being played back.
System setting parameters are saved to internal memory when you move to another screen by pressing [EXIT] (or in some other
way). These settings will still be in effect the next time the power of the D2 is turned on.
1. Press [SYSTEM] to enter System Edit mode.
Each time you press [SYSTEM], you will cycle through "Sound generator settings"
transmission settings"
* The beat scan display indicators below the NEXT display will blink to indicate the settings that you are making.
fig.8-1
2. Press [ENTER] to select the parameter that you wish to set.
3. Turn [VALUE] to modify the setting.
4. When you are finished, press [EXIT].
Sound generator settings
Indication
"MIDI reception settings."
Parameter
Explanation
MASTER TUNE
For tuning the sound generator. The displayed value is
the frequency of the A4 note.
SD ROLL NOTE
Select the instrument that will be rolled by SD ROLL in
NUMBER
D-FIELD. Within the rhythm set that is selected for
part R of the current pattern, the instrument having the
note number you specify here will be sounded. –> Pre-
set Rhythm Set List (p. 86)
RESONANCE LIMIT-
Determines the maximum resonance value for the
ER RHYTHM
rhythm part. Higher settings of this value will increase
the range of change.
RESONANCE LIMIT-
Determines the maximum resonance value for parts 1–
ER NORMAL
7. Higher settings of this value will increase the range
of change.
"Sequencer settings"
"MIDI
Values
27.4 (427.4)–40.0 (440.0)–52.6
(452.6) (Hz)
35–98
50–127
50–127
...
73
Advertisement
Table of Contents
