Copying A Pattern (Pattern Copy) - Roland Groovebox D2 Owner's Manual

Chapter 6. Creating an Original Pattern

Copying a pattern (Pattern Copy)

fig.PTNCPY
This operation copies a pattern to a different pattern.
Display
* The copy destination part can be specified only if the copy source part is a single part. If the copy source consists of two or more parts, each
will be copied to the same part.
* If you are copying the data of a part to another part within the same pattern, you can select only one part at a time.
It is not possible to copy between part R and parts 1–7.
66
Parameter Explanation
SOURCE Select the data that you wish to copy.
* Press the part button [R] or [1]–[7] of the part whose data
you wish to erase, getting its indicator to light.
TOP/END Specify the range of measures that will be copied. The CUR-
RENT display will indicate the first measure to be copied,
and the NEXT display will indicate the last measure to be
copied.
* This will not be displayed if Source is "SETUP."
DESTINATION Specify the copy-destination pattern.
MEASURE Specify the number of the measure in the copy-destination
pattern to which the data will be copied.
TIMES Specify the number of times that the data will be copied.
MODE Specify whether the data at the copy destination will be re-
placed by the copy-source data, or will be mixed with the
copy-source data.
Setting
ALL: all performance data,
PHRASE: only note data,
SETUP: only setup parame-
ters (p. 20)
001–END
A01–U00
001–END
1–32 (maximum)
REPLACE, MIX