Limiting The Patches That Can Be Switched (Patch Extent); Adjusting The Screen's Contrast - Roland V-Bass VB-99 Owner's Manual

Chapter 3 Global Device Settings (SYSTEM)
Limiting the Patches That
Can Be Switched (PATCH
EXTENT)
Setting upper and lower limits for the patches that can be switched
allows you to select only the patches you need.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 3.
3.
Press [F1] (MISC).
4.
Press [F3] (FROM).
5.
Set the lower limit of the patch selection with
the PATCH/VALUE dial and [F3] (FROM) or the
F3 knob.
6.
Press [F4] (TO).
7.
Set the upper limit of the patch selection with
the PATCH/VALUE dial and [F4] (TO) or the F4
knob.
* These settings are enabled in the following situations.
• When the PATCH/VALUE dial is turned
• When patches are switched with the control switches or
other controls
• When SYSTEM CONTROL ASSIGN (p. 42) is used to
assign PATCH SELECT INC or PATCH SELECT DEC to
the FC-300's control switches or expression pedal
switches
These settings have no effect on other FC-300 operations
or operations using an external MIDI device.
44
Adjusting the Screen's
Contrast
The text and icons in the LCD screen may be difficult to make out
sometimes, such as immediately after the VB-99 is turned on or after
extended use. The conditions at the place where you are using the
VB-99 can also affect visibility. Should you run into this problem, try
adjusting the contrast.
1.
Press [SYSTEM].
2.
Press PAGE [ ] to display Page 1.
3.
Press [F1] (LCD).
4.
Turn the F1 knob to adjust the contrast.