Recording The Data Of All Mc-307 Data On An External Sequencer; Restoring Data For All Mc-307 Data From A Midi Sequencer Back To The Mc-307; Checking The Amount Of Unused Internal Memory(Memory Information) - Roland Groovebox MC-307 Reference Manual

Chapter 7 Environment Configuration and
8. When transmission from the external device is
completed, Pattern Play screen appears.
* If you want to about the reception, press [F4 (EXIT)].
* After SETUP data has been received, use the Pattern Write
operation to save the setup to user pattern memory.
* After SETUP&PATCH or ALL data has been received, first
use the Patch Write operation to save the patches of all parts to
vacant user patches. Then use the Pattern Write operation to
save the setup and musical data as a user pattern.
Recording the data of all MC-307
data on an external sequencer
Before you begin, use a MIDI cable to connect the MIDI OUT
of the MC-307 to the MIDI IN of the external sequencer.
Approximately 1.1 MB (megabytes) of storage space is
required to save this data. You will need to use a sequencer
that is able to handle this amount of data. Roland models
that meet this requirement include the MC-80 (as of January,
2000).
Procedure
1. Press the [SYSTEM] button, and then the [F2 (UTIL)]
button.
2. Press the [CURSOR(up)] button.
The "3 BULK DUMP" screen will appear.
3. Press the [F3 (BULK)] button.
4. Press the [F3 (TXAL)] button.
The "BULK TX USER ALL" screen will appear.
5. Start realtime recording on your external MIDI
sequencer.
6. On the MC-307, press [F4 (EXEC)].
Bulk data will be transmitted from MIDI OUT.
Data transmission will end in approximately nine
minutes, and you will return to the pattern playback
screen.
7. Stop recording on your external MIDI sequencer.
* The bulk data will be transmitted with the device ID number
specified by the Device ID setting (P. 123).
130
Restoring data for all MC-307
data from a MIDI sequencer back
to the MC-307
To restore previously saved bulk data back to the MC-307,
use the following procedure.
Before you begin, use a MIDI cable to connect the MIDI IN of
the MC-307 to the MIDI OUT of your external sequencer.
Procedure
1. Press the [SYSTEM] button and then the [F2 (UTIL)]
button.
2. Press the [CURSOR(up)] button.
The "3 BULK DUMP" screen will appear.
3. Press the [F3 (BULK)] button.
4. Press the [F4 (RX AL)] button
The "ARE YOU SURE?" message is displayed.
5. Press [F4 (EXEC)].
The "BULK RX USER ALL" screen will appear. The MC-
307 will be ready to receive bulk data.
6. Transmit bulk data from the external device.
7. When the external device has finished transmitting the
data (It takes about nine minutes), You will return to
pattern play screen.
Checking the amount of unused
internal memory
(MEMORY INFORMATION)
You can check the remaining amount of internal memory.
Procedure
1. Press the [SYSTEM] button.
2. Press the [F2 (UTIL)] button.
3. Press the [CURSOR (up)] button.
The screen containing the "4 MEMORY
INFORMATION" screen appears.
4. Press the [F4 (INFO] button.
The "MEMORY INFORMATION" screen appears.
Press [F4 (OK)] or [EXIT] to return to previous screen.