Display; Function Button Section; Screen Controller Section; Meter Button - Roland RSS M-300 Owner's Manual

Display

5
fig.DisplayGuide.eps
This area shows mixer parameters, system settings, and meters.
You can use the CHANNEL EDIT section, the function button
section, and the screen controller section to perform operations
in the display.

Function button section

6
fig.FunctionSectGuide.eps
Use these buttons to operate the function buttons shown at the
bottom of the display, and to operate the tabs that switch
between display screens.

Screen controller section

7
fig.GenCtrlSectGuide.eps
4
1
2
Cursor buttons / Value dial
1
• Cursor buttons
These buttons move the cursor up/down/left/right in the
screen.
• Value dial
This adjusts the value of the parameter at which the cursor is
located.
SHIFT button
2
This button has the following two functions:
• Some buttons change their function while [SHIFT] is held
down.
3
Explanation of the panels
• You can hold down [SHIFT] to modify the range by which a
value will change when you operate the CHANNEL EDIT
section's knob or the value dial, allowing you to adjust the
setting in finer detail.
You can use the user preference SHIFT LOCK (p. 137) to change
the behavior of the SHIFT button.
ENTER button
3
Use this button to turn an on-screen button on/off, or to
confirm a change you've made to the settings.
HELP button
4
This button accesses the HELP CONTENTS popup. If you hold
down [HELP] and press another button, an explanation of
that button will appear in the HELP popup. This button will
light red while the popup is shown.
For more about using HELP, refer to the "Help function" (p. 163).

METER button

8
fig.MeterBtn.eps
This button accesses the METER screen where you can view the
meters. It will light red while this screen is shown.

EFFECTS section

9
fig.EffectsBtn.eps
1 2
INT FX button
1
This button accesses the EFFECTS screen where you can
control the effects. It will light red while this screen is shown.
EXT FX button
2
This button accesses the EXTERNAL INSERT screen where
you can control the external insert paths. It will light red
while this screen is shown.
25