Talkback/Oscillator; About Talkback/Talkback Return/Oscillator; About Talkback/Talkback Return; About The Oscillator - Roland M-5000 Reference Manual

Talkback/Oscillator

About Talkback/Talkback Return/

Oscillator
About Talkback/Talkback Return
TALKBACK
INPUT
TALKBACK
PATCHBAY
HPF
TALKBACK RETURN
TALKBACK RETURN
HPF
Talkback is a function that sends the signal from a desired input
connector to an output bus or output patchbay. This is useful in
situations such as when the operator sends instructions to on-stage
performers, stage managers, or staff. The M-5000 has three talkback
systems, TALK 1 through 3, and each can individually be assigned to
different outputs and set on or off.
Talkback return is a function that sends the signal from a desired
input connector to MONITOR 1, MONITOR 2, or HEADPHONES. It is
handy at times such as when returning instructions to the operator
from another booth or location.
You make the settings for talkback and talkback return in the
TALKBACK tab of the TALKBACK/OSC window.
0"TALKBACK/OSC Window TALKBACK Tab" (p. 184)

About the Oscillator

OSCILLATOR 1/2
PINK NOISE
WHITE NOISE
SEL LEVEL
SINE WAVE
MULTISINE
The oscillator generates noise or a sine wave and sends it to an
output bus or output patchbay. This is useful when, for example,
measuring a venue's acoustics or checking connections to external
equipment.
The two systems, OSCILLATOR 1 and OSCILLATOR 2, can be used at
the same time.
You use the TALKBACK/OSC window to make the settings for the
oscillator.
0"TALKBACK/OSC Window OSC Tab" (p. 185)
LEVEL TALK 1 ASSIGN
TALK 2 ASSIGN
TALK 3 ASSIGN
EXT
TO PATCHBAY
TO MONITOR
OSC
ON ASSIGN
TO PATCHBAY

TALKBACK/OSC Window

To display the TALKBACK/OSC window, go to the top panel and
press the [DISP] button in the talkback section.
The following two tabs appear.
Here you make settings for talkback and talkback
TALKBACK
return.
OSC Here you make the settings for the oscillator.
183